Blue Power 24/12 IP65 Waterproof (1)

The highest efficiency ever!

• Setting a new industry standard: with 93% efficiency or better, these chargers waste three to four times less heat. And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.

Adaptive 4-stage charge algorithm: bulk - absorption - float - storage

• The Blue Power charger features a microprocessor controlled 'adaptive' battery management. The 'adaptive' feature will automatically optimize the charging process relative to the way the battery is being used.

Less maintenance and aging when the battery is not in use: the Storage Mode

• The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2 V / cell (13,2 V for a 12 V battery) to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to 'equalize' the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.

Totally silent

• Models up to 12/15: no fan.

Protected against overheating

• Output current will reduce as temperature increases up to 60 ° C, but the Blue Power charger will not fail.

Two LED's for status indication

• Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off) Green LED: power on

Charger with built-in Bluetooth for communication and settings through your mobile. With up to 94% efficiency, the heat loss of these top chargers is three to four times lower than the specifications of similar chargers on the market. In addition, the battery is fully charged, power consumption is reduced below 0.5 Watt, a price about five to ten times lower than the specifications of the corresponding chargers on the market.

Charger Blue Smart IP 67 fully protected: waterproof, with protection against vibration and ignition
The Blue Smart IP67 charger is not at risk from water, oil or dirt. The housing is made of cast aluminum and the electronic components are made of resin molds.

Stop start
Models with suffix (1 + Si) have a limited second current output which is always supplied if there is a voltage of 180 - 265 VAC at the input. This output can, for example, be used to prevent the vehicle from starting before the battery charger is disconnected (start stop function).

Price without VAT