Lorentz PS150 Boost

1,270.00 
1,089.00  Excluding VAT
1,350.36  Includes VAT

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Available on backorder

  ... people are viewing this right now

  Share

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Weight 1 kg
Brand

SKU: Lorentz PS150 Boost Categories: ,

Most viewed products

Recently viewed products

  • -20%Limited
    Victron Phoenix Inverter C 24/1600 - 1300W Pure Sine Inverter for Photovoltaics 920.00 
    738.00  Excluding VAT
    915.12  Includes VAT

    Victron Phoenix Inverter C 24/1600 - 1300W Pure Sine Inverter for Photovoltaics

    Inverter (inverter) Victron of Dutch origin, for autonomous systems (photovoltaic, wind, hybrid). Pure sine, high efficiency and with high peak power at 3000W. Suitable for a wide range of applications, capable of providing power, without problems, to any load. Excellent professional quality compact and light. With the possibility of connection in parallel and three-phase layout.

    Technical characteristics

    Inverter off
    Power (W) 1300
    Manufacturer VictronEnergy
    Input Voltage (V) 24V DC
    Output Voltage (V) 230 AC
    Performance level (%) 94
    IP protection IP21
    Weight (kg) 10.0
    Warranty (years) 5
    Other Information Material & Color: aluminum (blue RAL 5012), Battery cables of 1.5 meter included, G-ST18i plug

    Available on backorder

  • -16%Limited
    Victron SmartSolar MPPT 250/60
    Victron SmartSolar MPPT 250/60-Tr - MPPT 60A Photovoltaic - Wind Turbine Charging Regulator 443.00 
    373.00  Excluding VAT
    462.52  Includes VAT

    Victron SmartSolar MPPT 250/60-Tr - MPPT 60A Photovoltaic - Wind Turbine Charging Regulator

    Extremely fast maximum power efficiency (MPPT) detection

    Especially in the case of cloudy skies, or when the light intensity is constantly changing, an ultra-fast MPPT controller will improve energy efficiency by up to 30% compared to PWM charge controllers and up to 10% compared to slower MPPT controllers.

    Advanced finding of optimal power efficiency in case of partial shading

    Victron battery charge regulators, thanks to the rapid detection of maximum power point (MPPT) technology from photovoltaic panels, even in shady conditions, promise the fastest possible charging of the batteries of the autonomous photovoltaic system, guided by the safety of the equipment and ensuring the required charging voltage of the batteries for their proper and long-term proper operation.

    Technical Features

     

    Model No.
    MPPT 250/60 MPPT 250/70 MPPT 250/85 MPPT 250/100
    Electrical data
    Max. Solar Input Power
    860/1720/3440 W 1000/2000/4000 W 1200/2400/4900 W 1450/2900/5800 W
    Max. Solar Panel Open Circuit Voltage
    250 V 250 V 250 V 250 V
    Max. Solar Panel Short Circuit Current
    A 35 A 35 A 70 A 70
    Nominal System (Battery) Voltage
    12 / 24 / 48 V 12 / 24 / 48 V 12 / 24 / 48 V 12 / 24 / 48 V
    Self-Consumption
    35 mA 35 mA 35 mA 35 mA
    Peak Conversion Efficiency
    99.00% 99.00% 99.00% 99.00%
    General Data

     

    Available on backorder

  • -20%Limited
    RENAC R1-1100-SS-grid-inverter for photovoltaics, net metering, photovoltaics on the roof, domestic
    RENAC R1-1100-SS R1 Mini Series Inverter 1100W Single Phase 470.00 
    374.00  Excluding VAT
    463.76  Includes VAT

    RENAC R1-1100-SS R1 Mini Series Inverter 1100W, Single-phase network inverter for photovoltaic. Suitable inverter for net metering, photovoltaic on roofs, home and professional photovoltaic systems.

    Available on backorder

  • -29%Limited
    Photovoltaic panel 200-205 watts Mono 199.00 
    142.00  Excluding VAT
    176.08  Includes VAT

    Photovoltaic panel ECO 200M power 200-205 watts Monocrystalline silicon.  Suitable for autonomous PV systems only with the use of high voltage MPPT charging regulators (above 90V D open circuit) . 

     They have a positive tolerance and power in watts. That is, they always deliver more watts than their rated power, high efficiency up to + 3% higher efficiency.

    Available with 12 years factory warranty and 25 years 80% performance guarantee

    Price without VAT

    In stock

  • -22%Limited
    EPSOLAR EPEVER-UP-3000W / 24V M6322 prices technical manual
    EPSOLAR EPEVER-UP-3000W / 24V M6322 HYBRID INVERTER / CHARGER UPower series 936.00 
    729.00  Excluding VAT
    903.96  Includes VAT

    EPSOLAR EPEVER-UP-3000W / 24V M6322 HYBRID INVERTER / CHARGER UPower series

    Available on backorder

  • -38%Limited
    7 OPzV 600 2V
    7 OPzV 600 2V GEL 452.00 
    279.00  Excluding VAT
    345.96  Includes VAT

    654AH - 945AH in a charging cycle C10 hours and C120 hours, GEL battery deep discharge

    The OPzV series consists of closed-type lead elements that combine proven gel and tubular plate technologies to offer high levels of reliability and performance.

    Price without VAT

    Available on backorder

  • -26%Limited
    μπαταρία-λιθίου lifepo4-200ah-_EPEVER_LFP12200_256KWH_12V_BATTERY-fotovoltaika
    200Ah-Lithium Battery EPEVER EP-LFP12200 2,56KWH 12V LiFePO4 12,8V with BMS and display 880.00 
    649.00  Excluding VAT
    804.76  Includes VAT

    100Ah-Lithium Battery EcoWatt LiFePO4 12,8V 100Ah 1280Wh with BMS and display for autonomous photovoltaics

    Minimum order 2 pieces. Delivery 5-7 days from France

    Available on backorder

  • -21%Limited
    ECOGEL 280 DEEP DISCHARGE FOR AUTONOMOUS PHOTOVOLTAIC SYSTEMS
    Ecogel 280 AH ECO SUN Deep discharge battery 575.00 
    452.00  Excluding VAT
    560.48  Includes VAT

    BATTERY OBM ECOGEL A-280 12 280 Ah 12V C100

     

    Deep discharge batteries OBM ECOGEL 280Ah is a very reliable and quality battery solution for energy storage systems. The batteries OBM ECOGEL 280Ah They provide maximum performance, resistance to overload and deep discharge while their construction is such that it provides them with high resistance to vibrations, vibrations and extreme weather phenomena.

    Rated voltage: 12V

    Capacity: 280Ah C100 (25oC)

    Charging-discharging cycles:> 1150- 1250 for DOD discharge depth 50%

    Dimensions: 520mm×269mm×220mm

    Weight: 70kg

    A 2-year warranty is provided

    Price without VAT

  • -19%LimitedSOLD OUT
    ECOGEL 100/110AH C100 GEL
    ECOGEL 100 / 110AH C100 GEL for photovoltaic & wind turbines 209.00 
    169.00  Excluding VAT
    209.56  Includes VAT

    ECOGEL 100 / 110AH C100 GEL Premium series GEL Long Life maintance free deep discharge batteries (without maintenance) deep discharge of high fidelity with a life expectancy of 10-12 years

    It is the best solution for small photovoltaic energy storage systems. Provide maximum performance and resistance to overload and deep discharge.

    They also provide high resistance to vibration and vibration. GEL technology closed type batteries completely waterproof, no maintenance required while delivering (approximately 1280 charging cycles)

    Suitable for Solar use in autonomous photovoltaic and hybrid systems, back up applications, UPS, permanent and holiday yachts (use of services), Electric Wheelchairs, wifi transponders & mobile telephony etc.

    Dimensions S. Energy ECO_ GEL100 / 110ah C100- Solar GEL VRLA

    Length:  260.00 mm
    Width: 170.00 mm
    Height:   210.00 mm
    Weight:  23.50 Kg.

    Up to 1280 charge cycles in DοD 50% of the discharge

    Price without VAT

    Out of stock

  • -28%Limited
    PHOCOS PSW-H-3000W / 24V HYBRID INVERTER Any Grid Germany
    PHOCOS PSW-H-3000W / 24V HYBRID INVERTER Any Grid Germany 1,499.00 
    1,079.90  Excluding VAT
    1,339.08  Includes VAT

    PHOCOS PSW-H-3000W / 24V HYBRID INVERTER Any Grid Germany

    Available on backorder

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Pump with controller Lorentz PS 150 Boost, with simple installation, without maintenance with high reliability, prices, offers

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category