Pump with controller

Specifications

Lift up to 165 feet (50 m)

Flow rate up to 9,5 gpm (2,7 m3 / h)

Simple installation

No maintenance

High reliability and life expectancy

Cost-effective solution

Application

Drinking water supply

Watering the animals

Pond management

Irrigation

PS200 controller

A controller for direct current or battery operation, indicating system status

Mounted above ground (does not sink electronics)

Two control inputs for better pumping (protection against dry operation) and the remote control (float or pressure switch)

Automatic reset 20 minutes after low water protection is involved

Protected from reverse polarity, overload and high temperature

Speed ​​control, maximum pump speed adjustable to reduce the flow rate to about 30%

Solar mode: integrated MPPT (Maximum Power Point Tracking)

Battery operation: low voltage disconnect and restart when the battery recovers

Max. efficiency 88% (engine + controller)

Housing: IP 54 (sealed, weather resistant)

Pump end (PE)

Helical pump rotor (positive displacement pump)

Only two main parts: stator and runner, in the field are repaired

Stat: geometry of abrasion resistant rubber

Runner: stainless steel, hard chrome, abrasion resistant

More resistant to sand damage than other types of pumps

Self-cleaning

Engine ECdrive 600 HR / 200 C

Brushless DC motor

No electronic engine media

They were filled with water

IP 68, pressure balanced, max. immersion unlimited

Dynamic sliding bearings, material: carbon / ceramic

Wetting material: stainless steel (AISI 316), POM, rubber, approved drinking water cable

Sand and mud Tolerance

The pump (HR) has a higher resistance to wear than sand and clay than any other type of pump. In properly constructed wells the amount of sand and clay is within the tolerance limits of the pump.

A solids concentration of more than 2% (by volume) can cause the pump or fall pipe to become clogged, especially at low flow rates.

Do not use the pump to clean a dirty well.

Pump cable and Splice

Standard submarine cable, 3-wire + + (four cables in total). Connection to the pump is made using industry standard splicing methods.

Drop Pipe

11/4 ", 11/2" or 2 "at the NPT pump output. If the water is dirty, consider a smaller pipe size drop to increase the flow rate. This helps deplete solid particles and prevent them from accumulating in the pipe. When considering reduced tube size, consult a tube size (friction loss) graph. Pipe can be made of any standard material, rigid or flexible. A torque extractor is not required.

Temperature limits

Pump tip, engine: water temperature up to +104 ° F (+40 ° C)

Specify the temperature range in the order

Controller: temperature -22 to 131 ° F (-30 to +55 ° C)

Warranty

2-year manufacturer's warranty against defects in material and workmanship

Price without VAT