Inverter- Pure Sine Charger MultiPlus 48/1200 / 13-16

Inverter- Pure Sine Charger Victron MultiPlus 48/1200 / 13-16

Two AC outputs

The main output operates as an uninterruptible power supply. MultiPlus takes over the power supply of the connected loads in case of failure of the network or when the main power supply / generator is disconnected. This happens almost instantly (in less than 20 milliseconds) so that computers and other electronic devices can continue to run without interruption. The second output is only active when the main AC power supply is available on one of the MultiPlus inputs. In this way, loads that should not be supplied by the battery in an emergency, such as e.g. a water heater, can be connected to this output (the second output is only available on power models 3 kVA and above).

Almost unlimited power thanks to the parallel operation

Up to 6 Multis can operate in parallel to achieve higher power efficiency. Six 24/5000/120 units, for example, can provide 25 kW / 30 kVA output power with a charging capacity of 720 Amps.

Possibility of three-phase supply

In addition to the parallel connection, three units of the same model can be combined to provide a three-phase supply. In case very high power is required, the ability to parallel up to 6 groups of three units, can give a combined inverter giant up to 75 kW / 90 kVA with a charging capacity greater than 2000 Amps.

PowerControl - Control the power supply

MultiPlus is a very powerful battery charger. Therefore, it can draw a very large current from the generator or the side of the power supply (almost 10 A per 5 kVA at 230 VAC). With the Multi control panel, you can set the maximum current that the device can draw from the generator or mains. The MultiPlus after taking into account the loads on the AC side, will give the excess power to charge the batteries, thus preventing the overload of the generator or the mains to which it is connected.

PowerAssist - Ability to compensate for the generator or network

This feature is based on Power Control. Allows MultiPlus to powerfully support the alternative source to which it is connected when the latter is in a state of weakness. Because maximum power is usually only required for a limited time, if the MultiPlus detects a fault in the generator or mains power supply, it can instantly compensate for this lack of battery power. When the load is reduced, the excess energy will be used to recharge the battery.

Solar energy: AC even in case of mains failure

MultiPlus can be used off-grid for autonomy from the grid, as well as on-grid to connect photovoltaic or alternative energy sources to it. Network loss detection software is also available.

System setup

- In standby mode and in case the settings need to be changed, this can be done in a few minutes with a DIP switch adjustment process.

Off-grid applications, network interaction and autonomy which include grid-coupled inverters and / or solar chargers MPPT, are regulated by the software "Assistants" (special software for specific applications).

- Devices with parallel inverters and three-phase supply are configured through VE.Bus Quick Configure software and VE.Bus System Configurator software.

On-site supervision and operation control

Available modes are: Battery Monitor, Multi Control Panel, Ve.Net Blue Power Panel, Color Control Panel, smartphone or tablet (Bluetooth Smart), laptop or desktop (with USB or RS232 connection).

Remote monitoring and operation control

Available modes are: Victron Ethernet Remote, Victron Global Remote and Color Control Panel.

The data can be stored and displayed free of charge on the VRM (Victron Remote Management) website.

Remote configuration

When the device is connected via Ethernet, you can access and change the settings remotely on the systems with Color Control Panel.