Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 30A 30A charge regulator

PWM 12/24V 30A Liquid crystal display

For status monitoring and adjustment

Output loading

Victron PWM 12/24V 30A Battery overcharging can be avoided by connecting all loads to the load output. The load output will disconnect the load when the battery has discharged to a preset voltage. Some loads (especially inverters) are best connected directly to the battery and the inverter remote connected to the load output. A special interface cable may be required, please refer to the manual. The connection and disconnection voltages are adjustable.

Day / night timing of cargo output

This option allows a preset ON-time after dusk.

Programmable battery charging algorithm

Programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (only with internal BMS)

Two 5 Volt USB outputs

Maximum current (both outputs combined): 2A

(VIC-BlueSolar_PWM-LCD-USB)

• Low cost Victron PWM 12/24V 30A PWM controller
• Internal heat sensor
• Three stages of battery charging (total, absorption, suspension)
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected from reverse polar connection of photovoltaic panels.
• Disconnects the output with low voltage
• Optional remote view (30A model only)

• PWM controller

• Programmable charging current ratio (normal setting: equal current for both batteries)
• Charging voltage regulation of three types of batteries (Gel, AGM and Flooded)
• Internal heat sensor and optional remote control heat sensor
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected from reverse polarity of photovoltaic panels and / or batteries.
BlueSolar 12/24-30 with 30A timer at 12V or 24V
• PWM photovoltaic lighting controller.
• The two timers allow operation from night time until sunrise or for a limited time after night and for a limited time before nightfall.
• Seven sections display the timer settings and analyze fault conditions.
• Battery status indicator with excessive battery discharge warning signal.
• Internal heat sensor.
• Three stages of battery charging (total, absorption, suspension).
• It is protected against overvoltage.
• It is protected against a short circuit.
• It is protected from reverse polarity of photovoltaic panels and / or batteries.
• With low voltage disconnects the device for bypass.
models: 12/24/48 Volt

Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 30A 30A charge regulator

Information about him Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 30A

Price without VAT