Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 20A 20A charge regulator

50.00 
42.00  Excluding VAT
52.08  Includes VAT

Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 20A Solar Charge Controller 20A Digital with Liquid Crystal Display for Photovoltaic Panels

Available on backorder

  ... people are viewing this right now

  Share

Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 20A Solar Charge Controller 20A Digital with Liquid Crystal Display for Photovoltaic Panels

Victron BlueSolar PWM Charge

Liquid crystal display

For status monitoring and adjustment

Output loading

Battery overload can be avoided by connecting all loads to the load output. The load output will disconnect the load when the battery is discharged to a predetermined voltage. Some loads (especially inverters) can best be connected directly to the battery and the inverter remote control connected to the load output. You may need a special interface cable, refer to the manual. The connection and disconnection voltages are adjustable.

Day / night timing of cargo output

This option allows a preset ON-time after dusk.

Programmable battery charging algorithm

Programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (only with internal BMS)

Two 5 Volt USB outputs

Maximum current (both outputs combined): 2A

(VIC-BlueSolar_PWM-LCD-USB)

• Low cost PWM controller
• Internal heat sensor
• Three stages of battery charging (total, absorption, suspension)
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected from reverse polar connection of photovoltaic panels.
• Disconnects the output with low voltage
• Optional remote view (20A model only)

Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 20A Solar charge regulator 20A

BlueSolar PWM Charge

• PWM controller

• Programmable charging current ratio (normal setting: equal current for both batteries)
• Charging voltage regulation of three types of batteries (Gel, AGM and Flooded)
• Internal heat sensor and optional remote control heat sensor
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected from reverse polarity of photovoltaic panels and / or batteries.
BlueSolar 12 / 24-20 with timer 20A to 12V or 24V
• PWM photovoltaic lighting controller.
• The two timers allow operation from night time until sunrise or for a limited time after night and for a limited time before nightfall.
• Seven sections display the timer settings and analyze fault conditions.
• Battery status indicator with excessive battery discharge warning signal.
• Internal heat sensor.
• Three stages of battery charging (total, absorption, suspension).
• It is protected against overvoltage.
• It is protected against a short circuit.
• It is protected from reverse polarity of photovoltaic panels and / or batteries.
• With low voltage disconnects the device for bypass.
models: 12/24/48 Volt

Price without VAT

SKU: BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 20A Categories: , , ,

Most viewed products

Recently viewed products

Victron BlueSolar PWM Charge Controller-LCD & USB,

Victron BlueSolar PWM Charge Controller-LCD & USB,

Victron BlueSolar PWM Charge Controller-LCD & USB 12/24V/20A Solar Charge Controller 20A Digital with Liquid Crystal Display for PV Panels

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category