Charging Regulator 10A with screen & USB

27.00 
19.00  Excluding VAT
23.56  Includes VAT

10A Digital Solar Charger with Liquid Crystal Display for photovoltaic panels

 
Only 19 pieces left in stock.
  ... people are viewing this right now

  Share

10A digital solar charge regulator with Liquid crystal display and USB for 150 Watt / 12v or 300watt / 24v polycrystalline silicon photovoltaic panels

Solar Charge Controller 10A For status monitoring and regulation
Output loading

10A Digital Solar Charger with Liquid Crystal Display for photovoltaic panels

Solar Charge Controller 10A Battery overcharging can be avoided by connecting all loads to the load output. The load output
will disconnect the load when the battery is discharged to a predetermined voltage.
Some loads (especially inverters) can best be connected directly to the battery and remote control
control connected to the load output. You may need a special interface cable, refer to the manual.
The connection and disconnection voltages are adjustable.
Day / night timing of cargo output
This option allows a preset ON-time after dusk.
Programmable battery charging algorithm
Pre-programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (only with internal BMS)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A

Beware of cheap imitations

Specifications: 10A digital charge regulator with Liquid crystal display for photovoltaic panels:

• Rated voltage: 12V 24V Auto
• Application: Solar system controller
• Current: 10A
• With timer and light sensor, it could work for the sunlight system.
• Only for off-grid photovoltaic system.
Safety instructions:

• 1. Make sure your battery has enough voltage for the controller to recognize the battery type before the first installation.
• 2.The battery cable should be as small as possible to minimize loss.
• 3. The regulator is only suitable for lead acid batteries: OPEN, AGM, GEL is not suitable for nickel hydride, lithium ions or other batteries.
• 4. The charge regulator is only suitable for setting solar modules. Never connect another charging source to the charger.

Character:

• 1. Built-in industrial microcontroller.
• 2. One key setting, digital display, automatic memory function.
• 3. Complete 4-stage PWM charge management.
• 4.Short circuit protection, open circuit protection, reverse protection, protection
overload • 5. Dual reverse current protection, low heat output.

System connection:

• 1. Connect the battery to the charge controller - plus and minus. 1 will be displayed if it detects a 12V battery, 2 if it detects a 24V battery.
• 2. Connect the PV module to the regulator - plus and minus.
• 3. Connect the consumer to the charge controller - plus and minus.
• The reverse order applies when uninstalling!
• An improper sequence can damage the controller!
• Size: 133x70x32mm / 5.2×2.7×1.3”

Note:

• Allow 0-2mm error due to manual measurement.

Price without VAT

Most viewed products

Recently viewed products

Solar Charge Controller 10A Digital with Liquid Crystal Display,

Solar Charge Controller 10A Digital with Liquid Crystal Display,

Solar Charge Controller 10A 10A Digital with Liquid Crystal Display for Photovoltaic Panels and USB Output For Status Monitoring

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category