30A digital solar charge regulator with Liquid crystal display for photovoltaic panels up to 450 watts / 12v or up to 900 watts / 24v Polycrystalline

For status monitoring and adjustment
Output loading

30A Digital Solar Charger with Liquid Crystal Display for photovoltaic panels

Battery overload can be avoided by connecting all loads to the load output. The load output
will disconnect the load when the battery is discharged to a predetermined voltage.
Some loads (especially inverters) can best be connected directly to the battery and remote control
control connected to the load output. You may need a special interface cable, refer to the manual.
The connection and disconnection voltages are adjustable.
Day / night timing of cargo output
This option allows a preset ON-time after dusk.
Programmable battery charging algorithm
Pre-programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (only with internal BMS)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A

Beware of cheap imitations

Specifications: 30A digital charge regulator with LCD screen for photovoltaic panels: 

System connection:

• 1. Connect the battery to the charge controller - plus and minus. 1 will be displayed if it detects a 12V battery, 2 if it detects a 24V battery.
• 2. Connect the PV module to the regulator - plus and minus.
• 3. Connect the consumer to the charge controller - plus and minus.
• The reverse order applies when uninstalling!
• An improper sequence can damage the controller!
• Size: 133x70x32mm / 5.2 × 2.7 × 1.3 “

Note:

• Allow 0-2mm error due to manual measurement.

Price without VAT