Victron BlueSolar PWM Charge

Victron BlueSolar PWM Charge Liquid crystal display

For status monitoring and adjustment

Output loading

Overcharging the battery can be avoided by connecting all loads to the load output. The load output will disconnect the load when the battery has discharged to a preset voltage. Some loads (especially inverters) are best connected directly to the battery and the inverter remote connected to the load output. A special interface cable may be required, please refer to the manual. Victron BlueSolar PWM Charge Connect and disconnect voltages are adjustable.

Day / night timing of cargo output

This option allows a preset ON-time after dusk.

Programmable battery charging algorithm

Programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (only with internal BMS)

Two 5 Volt USB outputs

Maximum current (both outputs combined): 2A

(VIC-BlueSolar_PWM-LCD-USB)

• Low cost PWM controller
• Internal heat sensor
• Three stages of battery charging (total, absorption, suspension)
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected from reverse polar connection of photovoltaic panels.
• Disconnects the output with low voltage
• Optional remote view (20A model only)

Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 5A Solar charge regulator 5A

• PWM controller

• Programmable charging current ratio (normal setting: equal current for both batteries)
• Charging voltage regulation of three types of batteries (Gel, AGM and Flooded)
• Internal heat sensor and optional remote control heat sensor
• It is protected against overvoltage
• It is protected against a short circuit
• It is protected against reverse polarity connection of photovoltaic panels and/or batteries.Victron BlueSolar PWM Charge
BlueSolar 12 / 24-10 with timer 10A to 12V or 24V
• PWM photovoltaic lighting controller.
• The two timers allow operation from night time until sunrise or for a limited time after night and for a limited time before nightfall.
• Seven sections display the timer settings and analyze fault conditions.
• Battery status indicator with excessive battery discharge warning signal.
• Internal heat sensor.
• Three stages of battery charging (total, absorption, suspension).
• It is protected against overvoltage.
• It is protected against a short circuit.
• It is protected from reverse polarity of photovoltaic panels and / or batteries.
• With low voltage disconnects the device for bypass.
models: 12/24/48 Volt

Information about him Victron BlueSolar PWM Charge Controller-LCD and USB 12 / 24V / 5A

Price without VAT