Non-inverting remote on-off cable

22.00 
16.00  Excluding VAT
19.84  Includes VAT

Victron Non Inverting remote on-off cable

Use this cable to remotely control BlueSolar and SmartSolar MPPT charge controller models.

Available on backorder

  ... people are viewing this right now

  Share

Victron Non Inverting remote on-off cable

Use this non inverting remote on-off cable from her Victron for remote control of BlueSolar and SmartSolar charge controller models MPPT.

Note that it is not necessary to use this cable on the larger SmartSolar models as they have a built-in Remote On/Off terminal.

The charger will turn on when the signal on the wire is high. The charger is disabled when the source signal is pulled low.

Note that when using this cable, the VE.Direct port cannot be used for any other purpose. Like connecting to a GX device, or for example a VE.Direct Bluetooth Smart dongle to a BlueSolar charger.

Victron non-inverting remote on-off cable

Use this cable to connect the following products to the VE.Bus BMS :
– Skylla-TG: all models
– Battery Protect models BP40i, BP60i and BP200i.

The cable translates the remote enable/disable of the driver from the VE.Bus BMS (normally high and open circuit in case of alarm) to the communication required by the above products: pull down to disable.

SKU: Non-inverting remote on-off cable Category: 

Most viewed products

Recently viewed products

non inverting remote on-off cable, victron, photovoltaic,

non inverting remote on-off cable, victron, photovoltaic,

Get the non inverting remote on-off cable at the cheapest price on the market. Cable for BlueSolar MPPT Charger, autonomous systems.

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category