Lorentz PS150 Boost

1,270.00 
1,089.00  Excluding VAT
1,350.36  Includes VAT

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Available on backorder

  ... people are viewing this right now

  Share

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Weight 1 kg
Brand

SKU: Lorentz PS150 Boost Categories: ,

Most viewed products

Recently viewed products

  • -16%Limited
    Victron BlueSolar MPPT 100/50 - Charge Regulator 50A-MPPT for Photovoltaic-Wind Turbines 179.00 
    150.00  Excluding VAT
    186.00  Includes VAT

    Victron BlueSolar MPPT 100/50 - Charging Regulator 50A-MPPT for Photovoltaic-Wind Turbines

    Advanced finding of optimal power efficiency in case of partial shading
    Victron battery chargers, thanks to fast technology maximum power point (MPPT) from photovoltaic panels, even under shading conditions, promise the fastest possible charging of the batteries of the autonomous photovoltaic system, based on the safety of the equipment and ensuring the required charging voltage of the batteries for their proper and long-term proper operation.

    Specifications

    BlueSolar Charge controller MPPT 100/50
    Battery Voltage 12 / 24V auto select
    Rated charging current A 50
    Nominal PV Power, 12 V 1a), 1b) 700 W (MPPT range 15 V to 70 V resp. 95 V)
    Nominal PV Power, 24 V 1a), 1b) 1400 W (MPPT Bereich 30 V to 70 V bzw. 95V)
    Maximum PV open circuit voltage 100 V
    Peak efficiency 98%
    Self-consumption 10 mA
    Charge voltage 'absorption' 14,4 V / 28,8 V (adjustable)
    Charge voltage 'float' 13,8 V / 27,6 V (adjustable)
    Charge algorithm multi-stage adaptive
    Temperature compensation -16 mV / ° C resp. -32 mV / ° C
    Protection Battery reverse polarity (fuse) / Output short circuit / Over temperature
    Operating temperature -30 ° C to +60 ° C (full rated output up to 40 ° C)
    Humidity 95% non-condensing
    Data Communication Port VE.Direct

    Available on backorder

  • -20%Limited
    Victron Lithium Battery, Lithium SuperPack 25,6V/50Ah (M8)
    Battery Victron Lithium SuperPack 25,6V/50Ah (M8) 1,380.00 
    1,110.00  Excluding VAT
    1,376.40  Includes VAT

    Battery Victron Lithium SuperPack 25,6V/50Ah (M8)

    The Victron Lithium SuperPack 25,6V/50Ah battery is a Lithium battery for a large number of charge and discharge cycles for very long discharge depths.

    Available on backorder

  • -43%LimitedSOLD OUT
    450watt wind turbine 859.00 
    489.00  Excluding VAT
    606.36  Includes VAT

    Wind turbine 450 watt / 12v (16m / sec) or 350 watt / 12v (11m / sec) German Technology, low noise, low start 1.8 M / S and high efficiency.

    Includes cotroller.

    Price without VAT

     

     

    Out of stock

  • -36%Limited
    Photovoltaic batteries, deep discharge lithium ion lifepo4 Motorhome - motorhome Lithium Battery ULS-12-150 AH Ultimatron LiFePO4 Lithium Battery 12.8V 150Ah / 1920 Wh
    Lithium Battery ULS-12-150 AH Ultimatron LiFePO4 Lithium Battery 12.8V 150Ah / 1920 Wh / with bluetooth and smart BMS with 5 YEAR warranty 1,389.00 
    885.00  Excluding VAT
    1,097.40  Includes VAT

    Performance Lithium Battery 1920Wh

    Lithium Battery ULS-12-150 AH Ultimatron LiFePO4 Lithium Battery 12.8V 150Ah with bluetooth and smart BMS with 5 YEAR warranty

    Minimum order 2 pieces. Delivery 4-6 days from France

  • -29%LimitedSOLD OUT
    5kW PPC Yingli Solar Photovoltaic with Installation 7,042.00 
    5,030.00  Excluding VAT
    6,237.20  Includes VAT

    5kw with photovoltaics on roofs with Yingli Solar 250 watts polycrystalline silicon

    It produces an average of 6500kw per year (for areas of Attica and south) εcovers an area of ​​35-40 square meters on a pergola or 60-80 square meters on a roof. It saves 800-1000 euros per year and absorbs the installation cost in 5.5 - 6.5 years. 

    Price without VAT

    Out of stock

  • -25%LimitedSOLD OUT
    Etatrack active 1500 2,576.00 
    1,932.00  Excluding VAT
    2,395.68  Includes VAT

    15 square meters covered area

    Price without VAT

     

    Out of stock

  • -23%LimitedSOLD OUT
    OBM ECOAGM 125Ah deep discharge battery 215.60 
    167.00  Excluding VAT
    207.08  Includes VAT

    BATTERY OBM ECOAGM A-125-12 125Ah 12V C100

    The 12V deep discharge batteries OBM ECOAGM 125AH are designed with AGM technology for use in UPS systems, security systems, alarms and fire safety systems, photovoltaic systems, autonomous power generation systems, electric elevator panels, emergency lighting, as well as for all uses that require backup power from a reliable
    accumulator.

    Dimensions:406 * 173 * 209mm
    Weight: 31.4kg

     

    A 2-year warranty is provided

    Price without VAT

     

    Out of stock

  • -27%Limited
    STUDER XTH 5000-24 4,648.00 
    3,399.00  Excluding VAT
    4,214.76  Includes VAT

    5000 VA 24 Vdc 230 Vac / 50 Hz with switching system and integrated 140A battery charger.

    Studer Xtender
    The Studer Xtender converter is the ideal solution for complex hybrid systems. It can be adapted and connected to PV panels, small wind turbines, diesel generators and even the public electricity grid, regardless of whether it operates as a single-phase or three-phase converter.

    Price without VAT

    Available on backorder

  • -19%LimitedSOLD OUT
    ecogel 100 ah ecosun GEL 100ah deep discharge battery for photovoltaic
    ecogel-100ah-battery-deep-cycle GEL photovoltaic batteries
    Deep discharge battery ECO SUN ECOGEL 100Ah, C-100/12V 192.00 
    154.90  Excluding VAT
    192.08  Includes VAT

    BATTERY OBM ECOGEL A-100 12 100 Ah 12V C100

    Deep discharge batteries OBM ECOGEL 100AH is a very reliable and quality battery solution for energy storage systems. The batteries OBM ECOGEL 100AH They provide maximum performance, resistance to overload and deep discharge while their construction is such that it provides them with high resistance to vibrations, vibrations and extreme weather phenomena.

    The 12V deep discharge batteries OBM ECOGEL 100AH are designed with technology GEL (JELL)  for use in UPS systems, security systems, alarms and fire safety systems, photovoltaic systems, autonomous power generation systems, electrical elevator panels, emergency lighting, as well as for all uses that require backup power from a reliable
    accumulator.

    Dimensions:260* 168 * 208mm
    Weight: 23.2kg

    A 2-year warranty is provided

    Price without VAT

    Out of stock

  • -26%Limited
    Pure Sine Inverter Victron Phoenix 12/2000 Smart 2000VA 24V with WiFi / bluetooth
    Pure Sine Inverter Victron Phoenix 12/2000 Smart 2000VA 12V 864.00 
    640.00  Excluding VAT
    793.60  Includes VAT

    Pure Sine Inverter Victron Phoenix 12/2000 Smart 2000VA 12V

    Pure Sine Inverter Victron Phoenix 12/2000 Smart 2000VA 12V

    with WiFi

    Available on backorder

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Pump with controller Lorentz PS 150 Boost, with simple installation, without maintenance with high reliability, prices, offers

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category