Lorentz PS150 Boost

1,270.00 
1,089.00  Excluding VAT
1,350.36  Includes VAT

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Available on backorder

  ... people are viewing this right now

  Share

Pump with controler 

Construction & features

Rotary blade mechanism (positive displacement) from forged

brass, carbon-graphite and stainless steel

Tighten the assembly to prevent alignment problems

Handles seawater, dissolved metals

Withstands a lot of freezes

Brushless DC motor (maintenance free) is the same for 12 and 24V

application with the same flow rates

MPP tracking, the existing amplifier for direct solar applications,

Speed ​​control pump, low voltage for the battery Disconnect

protection, Float terminal / remote control switch and low tide

catheter

Installation and Service Manual is extremely detailed and

is displayed

 

Suction capacity

5 meters vertically (20 ft), at sea level. Subtract 1 m for each

1.000 m altitude. Pump should be placed as low as possible and as close as possible

as much as possible in the water source. Absorbent capacity to me

less than intake pipe friction (or clogged filter) Intake

piping should be 1 inch or larger

 

Filter requirement

This pump can not tolerate dirt. The water must be purified.

If the water is very dirty, improve the source or consider a different one

pump

 

PV-Direct (without battery) Requirements

The rated power of the photovoltaic generator must exceed the pump watts

20% or more

A linear current MPPT incl (maximum power point)

monitoring) has already been included

Solar Tracker (optional) will increase daily output (40-55% on

the summer)

 

installation

The pump can be mounted horizontally or vertically.

The pump must not be submerged

Can be mounted inside 120 cm or larger housing,

suspended by a rope

accessory

 

Inline Filter: (10 “) Uses standard filter parts

Installation kit includes: pressure switch, pressure gauge,

control, drain and shut-off valves and TEE tank

Float switch for tank closed if full

Well Drought protection sensor of the pump

 

Dimensions

Pump unit length 33 cm

Βάρος: 7 kg

Controller 260 x 175 x 100 mm

Βάρος: 1,5 kg

 

warranty

1 year from defects in materials and construction

 

Price without VAT

Weight 1 kg
Brand

SKU: Lorentz PS150 Boost Categories: ,

Most viewed products

Recently viewed products

  • -16%Limited
    MultiPlus C 12/2000 / 80-30 120V 1,136.00 
    955.00  Excluding VAT
    1,184.20  Includes VAT

    The MultiPlus is a powerful sine wave inverter, a sophisticated battery charger with adaptive charging technology and a high-speed AC transfer switch, in a single compact box. Available in models from 500VA to 5000VA. MultiPlus prevents overcharging of a low voltage AC source. In the event of a fault in the network or if the power is disconnected from the ground source or the generator, the inverter inside the Multi is automatically activated and takes over the power supply of the connected loads.

    Available on backorder

  • Cyrix-Li-ct 12 / 24V-120A 55.65 
    54.65  Excluding VAT
    67.77  Includes VAT

    Cyrix-Li-ct 12 / 24V-120A

    The Cyrix-Li-ct 12/24V-120A Battery Combiner is a microprocessor-controlled enhanced relay that automatically connects batteries

    Available on backorder

  • Cable for Smart BMS CL 12/100 18.43 
    17.43  Excluding VAT
    21.61  Includes VAT

    Cable for Smart BMS CL 12/100

    This cable for Smart BMS CL 12/100 connects between a non-VE.Bus BMS) and a MultiPlus ( MultiPlus, MultiPlus Compact or MultiPlus-II).

    Available on backorder

  • -19%Limited
    Victron 12V/66Ah Gel Deep Cycle battery, gel type
    Victron 12V/66Ah Gel Deep Cycle Battery 269.00 
    217.00  Excluding VAT
    269.08  Includes VAT

    Victron 12V/66Ah Gel Deep Cycle Battery

    Victron 12V/66Ah Gel Deep Cycle battery that withstands repeated discharge/charge cycles using the full capacity of the battery.

    Available on backorder

  • -32%Limited
    Autonomous photovoltaic for a 4,5kWh cottage with air conditioning
    Autonomous PV for a holiday home 4,5kWh with air conditioner 2,600.00 
    1,780.00  Excluding VAT
    2,207.20  Includes VAT

    Available on backorder

  • -20%Limited
    solaredge-se-se3k-inverter-grid-photovoltaic, prices, specifications, purchase, cost
    Solaredge SE SE3K SETAPP network inverter for photovoltaics 1,133.00 
    904.57  Excluding VAT
    1,121.67  Includes VAT

    Solaredge SE SE3K SETAPP network inverter for photovoltaics. Suitable inverter for net metering, photovoltaic on roofs, home and professional photovoltaic systems.

    Available on backorder

  • -16%Limited
    Victron MultiPlus C 24/1600 / 40-16 - Pure Sine Inverter for Photovoltaics 840.00 
    706.00  Excluding VAT
    875.44  Includes VAT

    Victron MultiPlus C 24/1600 / 40-16

    Price without VAT

    Available on backorder

  • -22%Limited
    10 kW interconnected photovoltaic
    Photovoltaic solar energy: Photovoltaic Eco 545-550 watt mono half cell Eco ES -545MONO/182-144-European certified for autonomous photovoltaics - net metering - roof photovoltaics
    10kW PPC Photovoltaic ECO 545 Solar on roofs 6,800.00 
    5,300.00  Excluding VAT
    6,572.00  Includes VAT

    10 Kwatt photovoltaic on roofs with interconnected to PPC photovoltaic system with installation

    Photovoltaic Eco 545-550 watt mono half cell Eco ES -545MONO / 182-144-European certified for autonomous photovoltaic- net metering - roof photovoltaics

    Photovoltaic Eco 545

    See all offers here

     

    Available on backorder

  • -30%Limited
    Deep discharge battery OBM ECOAGM 50Ah, C-100 / 12V 128.00 
    89.90  Excluding VAT
    111.48  Includes VAT

    BATTERY OBM ECOAGM A-50-12 50Ah 12V C100

    The 12V deep discharge batteries OBM ECOAGM 50AH are designed with AGM technology for use in UPS systems, security systems, alarms and fire safety systems, photovoltaic systems, autonomous power generation systems, electric elevator panels, emergency lighting, as well as for all uses that require backup power from a reliable
    accumulator.

    Dimensions:196 * 165 * 170mm
    Weight: 13.5kg

    A 2-year warranty is provided

    Price without VAT

     

  • -16%Limited
    Victron Ethernet Remote IVI VIC remote control system 501.00 
    423.00  Excluding VAT
    524.52  Includes VAT

    The Ethernet Remote has the same functions as the Universal Remote Control System. An additional function of the Ethernet Remote Control System is that it can be connected to a LAN via a special cable. This way, the Ethernet Remote Control System can connect to the Internet without a SIM card.

    Price without VAT

    Available on backorder

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Lorentz PS 150 Boost, pump, PUMP, PUMP, pumps,

Pump with controller Lorentz PS 150 Boost, with simple installation, without maintenance with high reliability, prices, offers

My cart
Close Wishlist
Close Recently Viewed
Compare Products (0 Products)
Compare Products
Compare Products
Compare Products
Compare Products
Category